Avoid changing the lower tension unless you are sure that the tension cannot be corrected completely by adjusting the top one alone. The lower tension is adjusted by turning the small screw on the bobbin case using a screw driver. Usually the screw is turned to the right to tighten and the left to loosen. Make a very slight turn only, each time.

e. Reinforce around Armscye to form a good shape, using 3 to 5 inch strips. Some persons may wish a short sleeve cap. This is formed from 1 to 3 inches beyond armscye at shoulder tip, using short 3 to 5 inch strips building a smooth upper arm curve, allowing strips to follow the arm curve when pasting on. (It ids difficult to put on and remove garments with an extended sleeve cap). Finish the neck with one layer of 5 to 9 inch strips around the neck to form a good shape until dress form is removed from person. The neck can be reinforced more sturdily when form is removed.